Mоlimо vаs kоristitе оvај idеntifikаtоr zа citirаnjе ili оvај link dо оvе stаvkе:
https://open.uns.ac.rs/handle/123456789/10021
Nаziv: | Mechanical finishing honing: Cutting regimes and surface texture | Аutоri: | Vrac D. Sidjanin L. Baloš, Sebastian |
Dаtum izdаvаnjа: | 11-окт-2011 | Čаsоpis: | Industrial Lubrication and Tribology | Sažetak: | Purpose - The aim of this paper was to confirm the hypothesis that it is possible to conduct normal honing by mechanical method, providing the prescribed quality of cylinder liners. For this, cutting parameter optimization is needed. Design/methodology/approach - Normal honing was performed on grey cast iron with lamellar graphite and mostly pearlitic microstructure of metal matrix. Cutting speed, feed rate and specific pressure during metalworking were varied and accordingly, a mathematical model for processing of results by the least squares method was proposed. Surface texture was controlled by scanning electron microscope. Findings - A mathematical model describing the influence of cutting speed, feed rate and specific pressure during metalworking was devised. At the same time, surface texture was adequate, with geometrically appropriate crosshatch pattern, without standing-out material and mashed graphite lamellas. Originality/value - It was found that normal honing may be done by mechanical means, providing exceptional quality of lubrication. The most influential metalworking parameter was shown to be specific pressure. © 2011 Emerald Group Publishing Limited. All rights reserved. | URI: | https://open.uns.ac.rs/handle/123456789/10021 | ISSN: | 368792 | DOI: | 10.1108/00368791111169007 |
Nаlаzi sе u kоlеkciјаmа: | FTN Publikacije/Publications |
Prikаzаti cеlоkupаn zаpis stаvki
SCOPUSTM
Nаvоđеnjа
4
prоvеrеnо 20.05.2023.
Prеglеd/i stаnicа
25
Prоtеklа nеdеljа
7
7
Prоtеkli mеsеc
0
0
prоvеrеnо 10.05.2024.
Google ScholarTM
Prоvеritе
Аlt mеtrikа
Stаvkе nа DSpace-u su zаštićеnе аutоrskim prаvimа, sа svim prаvimа zаdržаnim, оsim аkо nije drugačije naznačeno.