Please use this identifier to cite or link to this item:
https://open.uns.ac.rs/handle/123456789/10021
Title: | Mechanical finishing honing: Cutting regimes and surface texture | Authors: | Vrac D. Sidjanin L. Baloš, Sebastian |
Issue Date: | 11-Oct-2011 | Journal: | Industrial Lubrication and Tribology | Abstract: | Purpose - The aim of this paper was to confirm the hypothesis that it is possible to conduct normal honing by mechanical method, providing the prescribed quality of cylinder liners. For this, cutting parameter optimization is needed. Design/methodology/approach - Normal honing was performed on grey cast iron with lamellar graphite and mostly pearlitic microstructure of metal matrix. Cutting speed, feed rate and specific pressure during metalworking were varied and accordingly, a mathematical model for processing of results by the least squares method was proposed. Surface texture was controlled by scanning electron microscope. Findings - A mathematical model describing the influence of cutting speed, feed rate and specific pressure during metalworking was devised. At the same time, surface texture was adequate, with geometrically appropriate crosshatch pattern, without standing-out material and mashed graphite lamellas. Originality/value - It was found that normal honing may be done by mechanical means, providing exceptional quality of lubrication. The most influential metalworking parameter was shown to be specific pressure. © 2011 Emerald Group Publishing Limited. All rights reserved. | URI: | https://open.uns.ac.rs/handle/123456789/10021 | ISSN: | 368792 | DOI: | 10.1108/00368791111169007 |
Appears in Collections: | FTN Publikacije/Publications |
Show full item record
SCOPUSTM
Citations
4
checked on May 20, 2023
Page view(s)
25
Last Week
7
7
Last month
0
0
checked on May 10, 2024
Google ScholarTM
Check
Altmetric
Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.