Молимо вас користите овај идентификатор за цитирање или овај линк до ове ставке:
https://open.uns.ac.rs/handle/123456789/6660
Назив: | Fixture layout design based on a single-surface clamping with local deformation | Аутори: | Tadic B. Todorovic P. Novkinic B. Buchmeister B. Radenkovic M. Budak, Igor Vukelić, Đorđe |
Датум издавања: | 1-јан-2015 | Часопис: | International Journal of Simulation Modelling | Сажетак: | © 2015, Vienna University of Technology. All Right Reserved. Proposed in this paper is a novel approach to fixture layout design. The contact interface between workpiece and fixture is reduced to a single workpiece surface. This allows reliable machining of the remaining five workpiece surfaces in a single setup. Workpiece clamping is performed by inserting special elements into prepared auxiliary openings on the workpiece. Clamping is thus reduced to indenting of sharp clamping element tips into the workpiece surface. Shallow indenting is performed on surfaces which have no practical function. Special device was designed to allow experimental investigation. Experimental results point towards the efficiency of the proposed approach. Workpiece displacements were small during machining and allowed the required machining accuracy. Furthermore, the results obtained during machining indicate high surface quality. | URI: | https://open.uns.ac.rs/handle/123456789/6660 | ISSN: | 17264529 | DOI: | 10.2507/IJSIMM14(3)1.280 |
Налази се у колекцијама: | FTN Publikacije/Publications |
Приказати целокупан запис ставки
SCOPUSTM
Навођења
10
проверено 03.05.2024.
Преглед/и станица
33
Протекла недеља
10
10
Протекли месец
6
6
проверено 10.05.2024.
Google ScholarTM
Проверите
Алт метрика
Ставке на DSpace-у су заштићене ауторским правима, са свим правима задржаним, осим ако није другачије назначено.