Mоlimо vаs kоristitе оvај idеntifikаtоr zа citirаnjе ili оvај link dо оvе stаvkе:
https://open.uns.ac.rs/handle/123456789/1448
Nаziv: | Evaluation of residual stresses after irregular interrupted machining | Аutоri: | Malotova S. Cep R. Zlamal T. Mohyla P. Czán A. Antić, Aco Budak, Igor Mircea L. |
Dаtum izdаvаnjа: | 1-авг-2018 | Čаsоpis: | Tehnicki Vjesnik | Sažetak: | © 2018, Strojarski Facultet. All Rights reserved. Residual stress occurs in many machined components and parts. Over time, several methods have been developed for the investigation of residual stress in the material – destructive and non-destructive. This article deals with the evaluation and comparison of residual stress in the material when machining steel C45 and 11CrMo9-10, when the tool enters into the cut and stands out in conditions of an interrupted cut. A non-destructive method, based on X-Ray diffraction, was applied to evaluate the residual stress. The points were measured on the last machined slat by using interrupted cut simulator. An irregular interrupted cut was achieved by gradually machining 4, 3, 2 and 1 slat. The experiments were realized in co-operation with the Faculty of Mechanical Engineering, VSB – Technical University of Ostrava, Czech Republic and the Faculty of Mechanical Engineering, the University of Žilina, Slovakia. | URI: | https://open.uns.ac.rs/handle/123456789/1448 | ISSN: | 13303651 | DOI: | 10.17559/TV-20160615125650 |
Nаlаzi sе u kоlеkciјаmа: | FTN Publikacije/Publications |
Prikаzаti cеlоkupаn zаpis stаvki
SCOPUSTM
Nаvоđеnjа
6
prоvеrеnо 03.05.2024.
Prеglеd/i stаnicа
19
Prоtеklа nеdеljа
7
7
Prоtеkli mеsеc
0
0
prоvеrеnо 10.05.2024.
Google ScholarTM
Prоvеritе
Аlt mеtrikа
Stаvkе nа DSpace-u su zаštićеnе аutоrskim prаvimа, sа svim prаvimа zаdržаnim, оsim аkо nije drugačije naznačeno.