Молимо вас користите овај идентификатор за цитирање или овај линк до ове ставке:
https://open.uns.ac.rs/handle/123456789/10064
Назив: | Effect of electrical pulse parameters on the machining performance in EDM | Аутори: | Gostimirović, Marin Kovac P. Škorić, Branko Sekulic M. |
Датум издавања: | 1-дец-2011 | Часопис: | Indian Journal of Engineering and Materials Sciences | Сажетак: | In electrical discharge machining (EDM) material is removed through periodical electrical discharges between the tool and workpiece. The electrical discharge energy which is transformed into heat in the discharge zone is of key importance in EDM. The machining performance of EDM is defined by the characteristics of electrical discharge pulse. For these reasons, the principle of EDM and the characteristics of electrical pulse parameters are analyzed in this paper. Discharge current and pulse duration are selected as the most important electrical pulse parameters. In addition, their influence on material removal rate, tool wear ratio, gap distance and surface roughness are experimentally investigated. The experiments are conducted on an manganese-vanadium tool steel using graphite tool electrodes. The study allows efficient identification of relevant electrical pulse parameters, and the results obtained represent a technological knowledge base for the selection of optimal EDM machining conditions. | URI: | https://open.uns.ac.rs/handle/123456789/10064 | ISSN: | 9714588 |
Налази се у колекцијама: | FTN Publikacije/Publications |
Приказати целокупан запис ставки
Преглед/и станица
35
Протекла недеља
12
12
Протекли месец
3
3
проверено 10.05.2024.
Google ScholarTM
Проверите
Ставке на DSpace-у су заштићене ауторским правима, са свим правима задржаним, осим ако није другачије назначено.