Молимо вас користите овај идентификатор за цитирање или овај линк до ове ставке:
https://open.uns.ac.rs/handle/123456789/4145
Назив: | Optimal tooth modifications for spur and helical gears | Аутори: | Simon V. | Датум издавања: | 1-јан-1989 | Часопис: | Journal of Mechanical Design, Transactions of the ASME | Сажетак: | A method for the simultaneous calculation of optimal tooth tip relief and tooth crowning for spur and helical gears is presented in this paper. The tooth profile modification is described by a linear function. Two types of crowning are introduced: linear and parabolic. The optimization of the tooth modifications is based on the following conditions: (1) The teeth are entering in mesh smoothly, without interference. (2) The load distribution factor is minimized. A computer program is developed for the calculation of the optimal tooth tip relief and crowning for spur and helical gears. By using this program the influence of type and length of optimal crowning and length of tooth tip relief on load distribution factor is investigated. Also, the influence of gear parameters on optimal tooth profile modification is discussed. On the basis of the obtained results, by regression analysis an equation is derived for the calculation of the optimal tooth tip relief. © 1989 by ASME. | URI: | https://open.uns.ac.rs/handle/123456789/4145 | ISSN: | 10500472 | DOI: | 10.1115/1.3259044 |
Налази се у колекцијама: | Naučne i umetničke publikacije |
Приказати целокупан запис ставки
SCOPUSTM
Навођења
2
проверено 03.05.2024.
Преглед/и станица
22
Протекла недеља
4
4
Протекли месец
0
0
проверено 10.05.2024.
Google ScholarTM
Проверите
Алт метрика
Ставке на DSpace-у су заштићене ауторским правима, са свим правима задржаним, осим ако није другачије назначено.